Velleman CHLSC1 Instrukcja Użytkownika Pobierz pdf (Strona 5)

CHLSC1

09.09.2009 ©Velleman nv

• Damage caused by disregard of certain guidelines in this manual is not covered by

the warranty and the dealer will not accept responsibility for any ensuing defects or

problems.

• Do not use outside the technical specifications (see §10).

4. Features

• for CHLS-series

• 4-line, 3-loop RGB controller with remote control

• controlled by push switch on the unit or through infrared remote (incl.)

• 20 pre-programmed output modes (single colours, flash, strobe, fade,…)

• high load capacity

• comes with screws and self adhesive strip on the backside for easy

installation

5. Overview and use

Refer to the illustrations on pages 2 and 3 of this manual.

LED Controller 7 DC in “-”

1 IR receiver 8 Data port “+”

2 RED status LED 9 Data port “-”

3 GREEN status LED 10 Output common “+”

4 BLUE status LED 11 Output RED “-”

5 Function select button 12 Output GREEN “-”

6 DC in “+” (12V or 24V) 13 Output BLUE “-”

Remote control

A Brightness adjustment (3 levels)

B On/Off button

C Light colour selection keys

D Mode selection keys:

• FLASH: 7 colours flashing

• STROBE: R, G, B - 3 colours “strobe-mode” alternately

• FADE: 7 colours fading out and in

• SMOOTH: 7 colours fading out and in smoothly

6. Installation

LED strips

• It is possible to connect either one RGB LED strip or 1 to 3 single colour strips

(red, green and blue). The LED strips can be either 12VDC or 24VDC driven.

Do not mix!

• First make sure all LED strips (not incl.) are securely in place.

• Mount the controller by using the adhesive tape on the back and the included

screws. Only install the device in a dry and easily accessible location with

sufficient ventilation. Note that the IR receiver [1] must be visible to use the

remote control.

• Connect the LED strip(s) to the controller outputs. It is recommended to use

at least AWG 12 wire (Ø2.053mm). In case of an RGB-LED strip, connect the

common [10], the red [11], the green [12] and the blue [13] outputs to

1 2 3 4 5 6 7 8 9 10 ... 26 27

Komentarze do niniejszej Instrukcji

Brak uwag

Velleman CHLSC1 Instrukcja Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oświetlenie Velleman CHLSC1